offset

Hi! for some reason my VS300 has decided not to save settings - example: the offset is constantly on .75 now and i change it to .25, press enter, back, go back in to make sure its still .25 and it is. but as soon as i hit print it reverts back so now im stuck with horns i cant get rid of because...

Hey guys, This is driving me nuts. I have my artwork done and put a cut box around it with a .02 radius on the corners. Everything looks perfect and checks out but when I open in in production manager and then send it to the plotter (hp branded summa, then again to my big summa T series) the...

Hey Guys, Have you ever experienced an issue where the Graphtec is not cutting where it should? We have an HP365 and we use Onyx Postershop Cutserver to print the artwork with the registration marks for the plotter to cut. I did print the cross pattern and then perfomed the Sensor Offset...

Anyone ever seen this issue on an HP 360. For that matter it may be a Flexi problem (presently using the cloud verson). see the attached print. (this happens to be on perf). Seems to be happening randomly near the end of prints. This last one happened three time in a row on the same file.

Hello. The cutter Plotter I am using is Mimaki CG-60 SR III. I have a few different materials I want to cut like 380 microns with glitter, 350 microns for shirt and 75 microns for stickers. I can’t seem to find the correct ratio between Speed Press and Offset. I already destroyed a lot of...

Hey guys! So I've been cutting with the ce-6000 for a while now and it's amazing, such clean and quick cuts compared to my old cutter. However I recently noticed that it was leaving nicks. I lowered the offset until those nicks disappeared, but now sharp edges are a bit deformed because the...

Hello! Im using a CG-160FX II with FineCut and Im having problems with the sizing. I was cutting circles and in the middle of the sheet it stopped cutting smoothly. I got it back to where it will cut smooth but its not cutting the right size now. I'm cutting with a 60 degree blade and have...

Hello, I have been having issues with a Zund M-1600 flatbed cutter. We only use a Z10 through cut knife in the machine and it cuts straight lines just fine. However when it gets to rounded corners especially small rounded corners it makes the cut and causes a rippling effect in the...

Hi guys. I just bought a used (almost new) CE5000-60. Have set it up, followed all instructions, but it still cuts HORRIBLY bad! I have posted 2 pics of my problem, that i cant seem to come past. I cut with original settings, and i use Signtcut pro as software with no altered settings. Do...

I just purchased a used Vinyl Express Q100. The previous owner only told me that he replaced the original blade holder with an aluminum one. After searching a bit, I believe that the holder is a Roland one and the extra blades he supplied me with are Roland blades. My question is how should I...

Alright, I'm so fed up with my printer right now.... So, We have this fairly large company ordering decals cause they are doing their whole fleet. They order roughly 6 sets per week and we just keep a running total and bill them every 5 weeks or so but recently we've changed the way we do...