Recent content by r2prints

Everything has a price, but it seems like too much legwork to keep it priced realistically. The only ways you could do it are 1. buy licensing to stock photos and spend countless hours on Photoshop work. 2. Hire a photographer to get everything you need, and again spend countless hours on...

Just narrowed it down as they are now printing another job, seems to be in Alabama! As you can see, I am about 1,200 miles away from Alabama.

Not really a problem, just throwing it out there. I have the HP Latex Mobile app on my iPhone. Last night at around 3AM, my phone starts freaking out saying my "Latex 360 is connected to this device"...weird, I thought. I have a 310. Brushed it off as a glitch. Wokeup in the morning, and I have...

Substance has already reached out to me due to this post. Top notch customer service from a business that truly stands behind their customers and products. What more could you ask for? Thank you Matt from Substance Inc!

Forgive me if this is the wrong section to be posting. Just got this shipment of laminate from Substance. It's their Ultracurve 1500 (15mil) I didn't notice these markings until a few feet in. They seem to be consistent about every 4 inches on the left half of the material. This is fresh out...

Look no further than Substance X1 or their X2 depending on how aggressive you need it. X1 should be just fine. I go through a few rolls a week exclusively for MX graphics. I am printing with an HP 310 and the only problem I have been having is the vinyl buckling in the curing chamber. Sucks to...

Seems like the safest bet is to dig into the router settings and tell it to leave the printer alone. Thank you!

It has been set on DHCP, there is also a "BOOTP, AUTO IP, and MANUAL" setting I can toggle. Would AUTO IP be another term for static? Thanks for the reply!

Hello all, Having this weird problem with my 310. For the most part, it is fine and goes without a hitch. I few weeks ago I was printing a nest job, 2 panels, about 10 feet long. All of the sudden, about halfway through the 2nd panel, it stopped printing and Flexi said "Cannot Open Port"...

Perfect, thanks!

Hi all, a few quick questions about upgrading to Flexi Premium from starter for HP. (Using an HP 310) I love the idea of streamlining my workflow, since right now I use Illy, Photoshop, and WinPlot simultaneously. As everyone knows, time is money, and I feel like I am wasting a lot of time...

Same thing happens to me with Substance X1. I thought it was only because I had one roll where the media was thinner than the backing paper, that was not the case. I usually can just clean it by picking off the adhesive with my finger. Not a huge deal breaker for me, once you hear the media...

^+1 Dual cure emulsions are rendered useless around 3 months after opening. I switched to Ryonet SVP after my first batch of dual cure was a mess. No looking back! It's a lot more forgiving than most make it out to be. Might be stupid, but have you changed ink cartridges in your film printer...

Do you laminate from a roll or do you cut pieces to size? I wish I could perfect cutting them to size as my print sheets are only 4 feet long, but each time I have tried has resulted in failure.

I think the most logical step would be to run the rollers against each other for a few hours. I will admit, I do not lift the rollers after I am done laminating as it seems cumbersome to align the laminate again but maybe I'm just lazy! I do run the machine everyday though. May be a smart...