• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Sinclair

  1. Roland Vs. Summa

    We are looking to buy a new plotter for our shop. I have been quoted a Summa D140 54" cutter and a Roland GX 54" Cutter. The sales guy suggest a Summa... I am looking for some feedback from others on there preference. What are others using and how well does it work? Thank you!

  2. Runtime Error on Techno CNC Interface

    Of course it was a stupid fix. Just a box checked that wasn't suppose to be while setting the file up.

  3. Runtime Error on Techno CNC Interface

    I am trying to cut some backs for channel letters and I set the file all up in signlab and then open it in the Techno CNC Interface. I zero the router in and then press Preprocess and an error pops up everytime. The error is "Runtime Error 11, Division by Zero" Does anyone have any idea what...

  4. Floor Graphics

    So I am thinking that 3M180-cv3 would work with a non slip lam?!

  5. Floor Graphics

    Looking for a vinyl to print on with our UV printer or solvent printer to go on the floor at our local mall. What are people using for print material and laminate? Any advice for installing? Should we use edge sealer? Thanks!

  6. Applying Graphics to Corrugated Galvanized Material

    Thanks Thanks everyone, even if we got a little side track, I think I got some good information.

  7. Applying Graphics to Corrugated Galvanized Material

    Vinegar, interesting! So what type of vinegar? ha skyhigh - WOW That is amazing! I bet that took sometime!

  8. Applying Graphics to Corrugated Galvanized Material

    I just got an e-mail to apply graphics to corrugated sheet of galvanized metal. I've read up on applying the graphics to corrugated metal but now I'm questioning weather the vinyl will adhere well to the galvanized metal. Does anyone have some input on this? I think I plan on using 3M180C for...
  9.

    Box Truck Rear Roll Up Door

    What do you use for an edge sealer?
  10.

    Box Truck Rear Roll Up Door

    What would you do? In the past we have done full wraps on box trucks and on the back door of the truck we have the measurements of each slat that separates when it is rolled up. So therefore we do individual panels. We have done both ways and done full panels then cut back where the slats...

  11. Will a windshield wiper affect a graphic?

    Thanks! I figured over time the graphic would so some wear and tear. I think as long as the customer knows that this will happen we should be all set. Yes, the Maine weather will help with the wear on it too. Thank you.

  12. Will a windshield wiper affect a graphic?

    We have a job coming up that may require to put graphics on a back windshield. Will the windshield wiper hurt the graphic? What are people using for material? Any other suggestions?
See more
Top