Search results

Try working in the center of the roller. Some of those are slightly crowned in the center and will cause wrinkles if you're working at the edge of the table. Good Luck,

https://www.multipaneluk.co.uk/assets/uploads/pdf/Fabrication-Manual-11-18.pdf

If your take up is pulling to the side, that could cause the paper to lift up, maybe not enough for a head strike, but enough to throw off calibrations. Try printing a roll without using the take-up. If you still have problems at least you know the take up isn't causing them. Check the dates...

The XR's are a very good, very stable printer. They've been out for quite a while now, so any bugs have been worked out of them long ago. Good Luck, Joe

Have you tried printing unidirectional? Double check your calibrations. Also, when things happen "all of the sudden" check your environment. If the temp is higher in your shop, or humidity lower, the ink will dry before it has a chance to spread out like normal. I've also seen static...

Not much difference operationally. Plus just added the swivel knife to the plotter.

What version of Versaworks are you using? (Help >About) Have you updated your firmware to the latest version available?

This should be under warranty, no? Why not call your dealer and get them on this?

I really am the last person you want to take design advice from:confused:, but what if you started with something like this: Or just do it with bare branches, like it's windswept: Just a starting point for you, like I said, I'm a mechanic, not an artist.:pops_blinking: Good Luck

Welcome to the jungle;)

Try these guys out: https://www.displaystar.com/

Every time you stop it, you reset it. Best to Judy let it run through ther ink up process.

If it's worked with these inks before, you probably have a bad chip on the cartridge. I'd ask Grimco for a replacement cartridge. If this is your first time with these inks, then they may not have the chips figured out yet. As a test to make sure it's not the chip readers on the printer, I'd...

How many labels can you buy for $3500? If that's your budget, keep outsourcing. Buying the printer is just the start of your expenses. How much had been budgeted for ongoing maintenance? What media? How much will that add? Ink? Space for the printer and related work area? As for the...

What do they bring to the table that's making you consider jumping off an ink set that you have confidence in? How much is that confidence/peace of mind worth? I don't have experience with either of them, I'm just curious what the motivation is. Good Luck

Make sure you're using a profile for the media you're printing on, then do a calibration for that profile.

Versa-Cam can be a SP-540v, SP-540i, VP-540, VP-540i, VS-540, but if it's about 4 years old, I would guess that it's a VS-540i. If so, when were the wiper(#25), felt(324) and wiper scraper(#26) last replaced? The wiper scraper tends to get neglected when doing the weekly cleaning. Also, I've...

Which model is it? VersaCamm is a series and there are quite a few models in that series. With different wiper systems. You don't want to turn off your your auto cleanings. This isn't a common situation in my experience. I would make sure that your wiper system is clean and consumable parts...

When was the last time you used it? And what is your definition of "routine maintenance"? Are all colors gone? Can you post a nozzle test print?

I had to help a shop with a similar situation. After a bunch of phone consulting I finally went onsite and found that they had an overhead air vent blowing directly on the back side of their printer. It was constantly blowing contamination on the supply side of the printer which, of course...