Search results

The captops should NOT have ink in them after a cleaning cycle. Please verify...

In the #Adjust menu are 3 items - Head ID, Serial #, and Dealer number. The serial number is for the printer itself, not the mainboard. However, it should match your printer, the head ID's should match your print heads and the dealer number you can get from your dealer to see if it matches...

That is the fast easy way and it works just fine.

Be sure to clear all the holes in the platen to ensure max vacuum suction.

Try office binder clips instead of tape, much easier...

The posts usually crack towards the bottom where they start to flare out. On the cartridge, I had marks on my forehead.

The magenta issue could be either the damper on that side or a cracked manifold or a bad head. Let's eliminate everything else before going for the head though. But, a head slapper thing - make sure both magenta cartridges have ink in them. I troubleshot that issue twice. The ribbon swap...

I'm betting your black issue is the off brand cap. Any defects or unevenness in the top edge of the cap seal will give you an air leak. Solventinkjet carries Roland OEM caps. Roland Cap Top | Solventinkjet.com I learned the frustrating way about the inconsistency of aftermarket caps and only use...

It does need to be centered. If the ink footprint is touching the silver frame around the head, you will have an air leak. Hard to tell as the pic is a bit blurry. Be sure to use the previous pic on mounting the head on the adapter. I would also gently clean the bottom of the head while it is...

Any luck?

The line between the cap and the pumps is likely clogged up. First move the print head away from the capping station and power down. Remove the cap line at the pump end, attach a syringe and try to pull cleaning fluid through the line. There are 2 lines, so do each one individually. If you...

Replace the dampers and upper O-rings on the cyan head, as well as the cap for that head. When replacing the dampers, snip off 1/16" off of the ink line so the upper O-ring is in an uncompressed part of the ink line. Please post your results...

I would suggest entering a best guess number, doing a quick small print, then go back in and print the bidirectional test again and see if the number range has changed...

Mike, Did your printer turn back on after a while? I would suggest checking the main power fuses. Very odd that it did this...

Sorry for the delay, busy fixing printers last week. OK, let's tackle the magenta and black heads. Remember, the cardinal rule in troubleshooting is to change only one thing at a time and test the results. First, we will determine if this is a signal issue, as we have don't have a single nozzle...

I will get back to you later today on this. There are a number of steps you need to take to determine what else is wrong. I am on the road and have limited access today.

If the tech does the damper fill two times, it should fix the issue. I would have him do it now anyway so you don't lose any prints to ink dripping.

The white will print wherever there is a pixel value that is not pure white. If you look at the jpeg you were trying to print in image editing software, I will bet you see color values at the edges that you thought were white. Rasterlink will see that value and print white. When you converted to...

If you are still using VG inks, you can do it yourself if you know how to go into service mode. If you have converted to VG2 inks, a tech must do it, thank you Roland! A lot of VG owners unhappy about this and rightfully so... Although the tech should come out and fix the mistake, if this is...

Did the tech replace the damper on the head he replaced? If the damper was the latest version, there is a revision on the dampers for that printer, and the damper fill needs to be done twice in a row. The new damper is designed for the VG2 inks, and the membrane needs to be "stretched" a bit...