Search results

warning it goes back to factory language hows your japanise, bin there done that. by chance you have not got tangental emulation switched on have you.

check what ken has said also you may find that the step command is different in cm2 and the plotter settings. welcome from the UK woolly

hi imo the black head is out of alignment in effect its twisted. there is a adjustment and test print to set that up. might have been the head crash that gave it a nudge. on std vinyl with colorrip 2.2 use 720x720 8 pass bi dir. should be band free. woolly

only thing i have seen simular before was the up down slider was sticky but this was a intermitant type of fault.you can test your software by output to a file then open the file in notepad , you should be able to see the first down pair of coordinates and the last pair , they should be the...

in cutting master are the units and step set correctly this will affect output sizing woolly

i would take the top cover off to see if the cables ink lines have not been dislodged. i would not use it much if at all till you know what it is. woolly

happened to me magenta running dry once new cart and a power clean sorted it. since then heard of about 4 others all magenta thought the problem had gone away are they quite old. if it has not recovered after a power clean i would check that the pump is working well, as this is what sucks the...

excellent work flow Paul and the finished result would be nice and crisp woolly

on the soljet family the key to press when it stops looking due to a unexpected long feed length and to get it to carry on searching is the 'pause' key, it may work on the cm. thanks to guys down under for that one woolly

did you notice that the mag clinged to the bed of the 7000. there is more alloy on the roland which did cut it but the feed calibration was way off. to be honest more trouble than it was worth woolly

should find what you want i also think that its set in the wrong language woolly http://www.graphtecamerica.com/support.html#a

hi on the print and cut machines the not found limit i think is 16 ft. but gives you the option to carry on, i am surprised that this is only 3ft. i will ask what the key is. woolly

never used it but i would expect the lexedge to work in the pc60. woolly

step size should be left alone as i think it will change the plotted size. you can alter the step pass that will ignore some of the steps with out altering size, normally set to 0. over the years i have noticed that the graphtec driver is touchy about some paths. corel contour is the worst...

as said. as i don't want the find sheet facility the rear sensor was covered from day one so did not know there was a possible problem. woolly

i have a fc 7000 and cant find that cross cut adjustment, it says in the manual its 15mm from the last command. only suggestion is to set a page length to where you want it cross cut. woolly

normally cause for ink drops are the pumps not sucking the waist away completely and or the wipers poor condition. the fact that you had just cleaned it is also a pointer to this. woolly

it really needs to do some more work and you are leaving it switched on yes. the capping stations and pumps must be sealing and working correctly for the cleaning to work woolly

i would have a closer look at the pumps and capping stations. has this machine had the upgraded pumps fitted. also the yellow is starting to fail in the same area indecating the pump may be poor woolly

hi looking for something else and found this may be may be not, but you shold be running in the other mode anyway woolly • Circle-Command Resolution Setting (CIRCLE RESOLUTION) Note: This function can only be specified when the COMMAND setting is HP-GL™. This function sets whether the...