Search results

If I need to manipulate the graphic after adding contour cut, I just clear the contour cut completely first. Make my changes, then add the contour cut again from scratch. I always make sure it's the last thing I do prior to printing. Then (most of the time) I remember to double check the...

The wound is dressed properly with Talfa Dressing and Polysporan (good friend is a critical care paramedic on an air ambulance helicopter= access to near-expired first aid products and good advice) However, the finger is protected with steel strapping and electrical tape. As my friend put it...

That is why I thought I'd tell the story

As stated above many times. A gesture like that is surely a reflection of how well you treat others. And kudos to your crew for appreciating how good they have it too.

Wait Wait Wait. You don't really like beer? I knew you weren't perfect! Seriously. Thanks so much I will be touch soon.

I did not know that prints look better on matte. I've been using gloss media, but most prints I laminate I use matte lam. becasue I like the look better. Matte for my next order it is. I love this site!

I am being told that most of it will regenerate back so I am more optimistic about it than I was yeaterday. And still surprised that there is not a lot of pain. I also noticed I'm not the only one who waited for a cut before buying a safety ruler. When I was renovating my first house in my...

Wow, it looks like a common injury in this field. I don't feel quite as stupid as I did yesterday. Still feeling a little stupid though.

Actually, it happened while I was on my first cup of coffee and when I got back from the hospital, the pot had shut off and my second cup was cold. So it was even more of a tragic day than I had first thought. I'm going to bed and try and sleep with my hand on my chest all night. Got a piece...

Thanks. I hope it's much less than twenty years. But Thanks.

Was looking at track saws, but thought this might be nearly as good for cutting dibond sheets. Although the reviews say it's a pain to attach, having a dedicated saw just for this might be an economical way to go. Any experience with this out there...

Cut the tip of my index finger off today on a 45 degree angle almost to the top of the nail. Happened first thing this morning. I am very angry at myself and absolutely horrified that my guitar playing days may be over (fret hand). My dad was a carpenter and boat builder his whole life (and a...

Ok, so I'll try and post all my questions at once while I try my first 3-D sign. But before I pick up some styrofoam. Can you advise if Type 2 is adequate or do I have to use the dense Type 4 (below grade) for slabs and foundtions. I'm really excited to start on this. Unfortunately I have...

I was thinking of my logo. I will give it a try and shoot any questions I have as I go along. Thanks so much.

Since I first saw the 3-D Dodge logo 3 hours ago, I just built a hot wire saw and tried it. It works. Now, to the lumber yard tomorrow for some styrofoam. The only question is. What should I make first?

In regards to the fiberglass resin. Are you using polyester or epoxy? I'm guessing polyester to keep the costs down. And do you clear-coat them after if they would be used outside? I think I may want to try this process.

You nailed them both. Thank You!

Any help would be great.

Looks to me like a bunch of men in tights holding hands.

25+ knots per hour. This year they had to be picked up by a freighter at an undiclosed location to be moved through pirating areas. The militaries of the world could not escoert them becasue the military does not have any equipement that will keep up with these open 70 racing boats for days on...