Search results

I see what ya did there...:rolleyes:

We use R-Tape brand in silver and holographic for a clients product. No complaints so far and it's been 2 years.

My SP540V was acting up on contour cuts and the encoder strip was clean. I ended up removing the sensor to clean it, then re-install. Had to go through a bunch of testing and a couple linear calibrations, but it works decent now. IIRC I'm at 0.00mm scan and 0.02mm feed. Before I started it...

Call Summa. They have always been helpful. Bet they even have repair parts for that unit too.

We use three tiered pricing. All decal orders are priced per square inch. Volume dictates tier. This works for us. Your results will probably vary wildly.

Ditto

Laser, paint, sand, finish.

Wow. Hacked 33% off the price shortly after launch. White elephant sale perhaps?

Flexi does not play well with certain anti-virus, spyware or adware blockers. We were having intermittent issues until we started shutting them off. Ta-da. We now use Advanced System Care which is an all in one deal. Inexpensive too. It was recommended and installed by our new computer tech...

Forget to tell you that Summa has factory refurbs.

Price a Summa....

My offer still stands. Send your non-functioning routers to me. I am going to build my own and will take whatever I can get.

Sub out the design/printing/laminating until you're sure you're going to make bank. Focus on installs only. Owning equipment looks good until you actually own it. You will have a huge chunk of money tied up into something that requires your full attention. Then you get to buy...

Gotta look at the whole supply chain. Printer may get it knocked out same day. Doesn't mean UPS or FedEx can't screw up. You're also ordering by computer an we all know they are far from perfect. We had a rush job earlier this year where our sub did it in record time. Only issue was the...

Encoder was dirty so it got pulled, cleaned, and reinstalled. When in Service menu it wouldn't let me do a linear encoder setup cycle. Which needed to be done since the cut was WAY off. I read, and reread the instructions. Systematically tried different methods to try and get it to work...

We use 8" poly tubing right now. Works well for most everything we do. Real nice for bagging banners.

Used corrugated core once. Never again. Only use DiBond or Omega. Most things we do are single sided so DiBond randoms work well.

It's a dog eat dog world and sometimes you're the guy wearin' the Milk Bone underwear.

My morning laugh. Thank you.

:popcorn: