Search results

what firmware version do you use and how old is your 1604?

try to access the serial number on the parameter by entering in the maintenance mode, check if its the same as the sticker attched outside your casing at the back near the mainboard box, does your printer comes in stock, or you alter in your parameter or firmware?

try to replace your head cable, maybe its worn out, and its the main reason why the f2 fuse blow, if the problem still persist its time to have a new printhead

yes better try fieldcenterusa.com look for francis...

definitely F2 fuses located in the mainboard near the black heatsink, how old is your machine if your board is new version the fuse is removable but if you have the old ones you might have to solder the fuse to it, I have done this many times

Good day! hi is it possible to convert a VJ1604 w1 waterbased into a eco solvent one? anyone has knowledge about this?

exactly right but you messed it up by upgrading the firmware, the only thing is to replaCE the mainboard

adjust two screws that controls the tension on left side of the printer, have someone push your carriage from left to right slowly while you turning the screws to see if the belt is aligned. you can say that its aligned if its not riding up and down.

yes that's true, mutoh is so smart that they allow us to upgrade and say that it will make our machine better, but the only reason is to protect their ink against third party ones.. damn.:noway:

its quite a small upgrade that you did not even notice because the main purpose of that is to secure/protect their inks, to be able to run in their system and read only original oem inks. japs was so genuis:notworthy:

what error did occur?, i have an older 1.10 and 1.06 pm me or send me email jugski@yahoo.com, i can help you

sharing my exp. I been encounter a lot of these the culprit is the head itself always start on cyan nozzle dunno why, but our assessment is head signal are damage theres no way to repair it but to replace a new head even though you perform a lot of soaking and purging it will be okay for a...

you can easily hear which valve open up when you look closely on it

your very lucky, anyway you got private message

1604 potential try to change all parts pertaining to ink system so that it will perform like a new one

you can try to purge ink manually to your head, pm me for instruction

its seems that capping issues, can you post a nozzle check test print pattern? maybe a clogged yellow nozzle

replace head and head cables even the dampers

this happen to me before, i just re install the whole program or try to install it to a new computer to diagnose the problem

its an blown f2 fuse issue, try this http://www.signs101.com/forums/showthread.php?p=581773 or search for f2 fuse issues there's a previous thread here