Search results

We got this error on the 110 today. Did anyone have any luck? I'm planning on trying to reseat it tomorrow when I'm back in. Edit: wow. I completely didn't notice I was the OP. I guess it just started working because I don't remember this.

I put the mounted foamcore face down on a large sheet of glass and trim off the excess with a very sharp box cutter. With practice it will come out looking very clean.

Has anyone run into this error? 17.3:11 Remedy:1. Check that the Main PCA to PrintMech black 1 cable is not damaged. 2. Check that the Main PCA to PrintMech black 1 cable is correctly connected to the Main PCA and the PrintMech PCA. 3. Replace the Main PCA to PrintMech black 1 cable. Can...

Thanks for all the suggestions. I'll probably do some stainless through bolts, and fill the holes if I go in a different direction. I went with polycarb because it was the material I had on hand after a sneezegaurd job.

Weaving it could be an option but I would like for it to go to the ground to keep the sand out. In the long term I'll have grass up to the fence in some places but in the short term it will be on the vacation rental market and I'm trying to keep the pool guy happy.

Hey Everyone, I have a personal project where I'm trying to adhere .060 polycarb sheeting to a PVC slatted fence to keep debris out of the pool. Since it's a brand new fence I'd rather use an adhesive than hardware. I thought grimco banner tape would hold it at first thought but it failed the...

Icing on the cake is now in addition to the fees any ground package +48" is no longer guaranteed by it's commit date Sent from my SM-G955U using Tapatalk

I have a 110 and it does not make that noise at idle. It makes that noise usually while it's preparing to print. Sent from my SM-G955U using Tapatalk

I've used 4over for banners and don't think the quality would be acceptable for 1-2 foot viewing. From 10ft absolutely, but there was still graininess from 3-4 feet from a vector text file.

Thanks for the help!

I have a customer looking for a .25" non-corrugated plastic sign with raised lettering similar to the one below. Can anyone recommend a vendor to produce this or somethign similar?

Thanks a lot guys. I'll inspect and replace, and of course report back. I really appreciate the picture of the dampers.

I see, do you happen to know if the damper is built into the print head on this model? I don't know where else it would be...

Replace even though it was recovered successfully? What is happening to the printhead internally that it would need to be replaced? What will raising the voltage do / compensate for? Thanks for the help, I'm still learning

Guys and Gals, I'm printing a banner that consists of mostly magenta, after about 9 feet the magenta started to band. I double checked the heater settings and they were all correct according to the manual. Afterwards I did an IQ Test Print and the banding was still there. About an hour later...

I used the ink below and was happy with it. http://www.amazon.com/LD-Remanufactured-Replacement-HP-Yellow/dp/B002M3REPW/ref=sr_1_2?ie=UTF8&qid=1383093936&sr=8-2&keywords=hp+5500+uv+ink

Thanks SignBurst! Looks like 32 bit is also in that directory, OP.

Hey everyone, I've been lurking on these forums a few weeks and figured I'd drop some information about myself. I'm from Virginia, and picked up a Designjet 5500UV about a year ago as an introduction to wide format printing. The machine needed a bit of work to get it operational, but with some...

What Operating system? If it's windows, you need a driver. I haven't come across a x64 driver yet.