Search results

Do what I did. Install a second NIC and run it direct. Haven't had a RIP hiccup since.

Why even comment then?

It's only used with 4 point marks, in the same drop down list of Reg Marks. When you do your contour cut, it runs you through the steps to line up with the laser.

I have started a habit of turning off the plotter and then back on right before I do any critical contour cutting. 9 times out of 10 if I have trouble with cuts lining up to the print, restarting the machine solves it. Don't know why....guess it's backed up/excess bits and bytes in there.... I...

I used to do a bunch of Safety-Kleen Connect vans, and they shipped us the graphics like this. They were liquid laminated. As suggested, install as much of the flattest areas as possible with the tape on it, then when you get to the trickier curves and tucks, peel off the tape so you can apply...

Also get you a Sealer Pen and run the sealer across the bottom (all edges even better) so that any up and down of the window doesn't start to peel the perf off.

Too many variables. I've had some heads last way too long, some not long enough. If you have a head strike, because of edge guards (I've had it happen) it most often only trashed head no 1, a C/Lc head. So Keep extras of those on hand. I've had to replace one with maybe 1 hour of printing on it...

Oh...I don't have a print take up on ours....600-S. This is our usual setup.

Not understanding your question..print to the take-up reel?

I usually only lose about 12" length on ours to get it loaded....I just get the liner taped up on the take up (I slip an old material core on the take up so I can just pull that whole thing off and toss it). Then pull out enough laminate to stick to the back platform, pull the print up under the...

Also use a LOW tack pre-mask.

Have never heard of nor tried that....I use alcohol to remove adhesive, so I can't even imagine using it to help adhesive vinyl stick better....

Rapaid Tac II is for cold, but they say down to 20. Just be patient and slow peeling the pre-mask.

Nothing related to Adobe previews for me... PDF, AI, PSD all show different icons. Always has been frustrating.

3620 here too, but it is not Air Release.

I think you should adjust the Vacuum setting as well...if it's pulling too hard that will cause the material to bunch.

What do you mean by profile? And for a plotter? Do you mean drivers? You need the install disk and you have to add the machines in Production Manager.

Yeah, that's if you have mostly large corporations for customers, who normally can supply CORRECT logos (many of BOTW logos are crap....they LOOK ok, but often are not 100%). Most logos you have to cleanup/recreate are small businesses who had their secretary make something in MS Paint or Word.

Ah...we just have the standard books then. Only shows numbers for mixing other pantone inks. Must get this one.

I just have to laugh at people that get on a SIGN forum and rant about ridiculous BS like this....even thought it's the "General Chit-Chat" section....still. Come on.