Search results

Yes, leave them engaged. Seems to really depend on the tension that the media has to begin with. But it seems to help across the board for more consistant feed.

Yes, the little locks are for tension. They should both be engaged. Loosen up the screws and push the lock slot into one of the tabs on the tension device.

this undefined paper error can occur when the room lights (or sunlight) artificially trigger the sensor.

The Spectrovue is driven by the RIP when creating profiles and is self contained in the printer for simple process control. Documentation is here: ftp://ftp.mutoh.com/Printer%20Information_Manuals/SpectroVue%20VM-10/

When using a cross over you must disable DHCP:http://www.mutoh.com/kb/entry/8/ The USB port is a hold over from the CAD printers like the RJ-900 (which all used the same design motherboard). The USB port requires a Window driver, and no Windows drivers have been written for the 1304...

I typically run 35-40 preheat 38-44 platen 50 dry. So you are in the ballpark. Sounds more like the media. Are you getting a smooth print, with no anomolies?

What are your heat settings? Dry should be high, but pre and platen should be lower. You may be overdrying the ink before it gets a chance to hit the media and embed.

Sounds more like a media issue than profile. But you can reduce your Ink Limit in the Color Transforms Configuration.

I quess the question is why do you think it is a feed issue? You didnt mention Front to Back alignments? Are those good?

Have you done a page feed adjust?

If it the 1614 it is located behind the left end cover. It is a circular disk.

JP, Just found out about a week ago that you were gone. I hope you are doing well. I did scratch my head, the Vegas location threw me. Drop me a PM and let me know what you are up to.

Uni and Bi directional alignments. It will have these for all the available head heights.

Front to back alignments are off. Probably slants and timing adjustments as well. Needs mechanical and electrical adjustments.

I think ProWraps is on the right track. Check the top menu structure for some thing like "Options". Or just look through them until you see a set of menus with check boxes that turn the options on in the "Set Up" menu. Check IP, etc. Mutoh's have the ability to remove options from the...

No more like something I missed. Just placed them. ftp://ftp.mutoh.com/Printer%20Information_Manuals/VJ-1624/Manuals/

I would go with the encoder first. Could be signs of a cable issue or a failing head.

For a forum.... http://www.isay.com/

I have seen it done with full solvent. The paper fibers wick quite a bit, and the paper is thin so density and resolution wasnt all that great. It took a custom profile and served the needs of a small grocery chain.

End of a cycle is different from end of time. Telling time is all about cycles. Not fortelling the future.