Search results

Reload Default Preferences and restart Flexi. Possible corrupted driver file

This is a common adjustment on the printer. 99% sure it is hardware. If I had the Service Document, I would help more but I do not.

There is an EndUser adjustment, that I do not think will resolve your issue, and there is a ServiceTech adjustment, that should fix the issue. Authorized service tech can get the procedure in PDF format or help you over the phone possibly.

Are all 100 decals mis-cut or just some of them?

Very nice. Now sell him a banner to replace the faded one on the wall :)

I would recommend resetting the unit to factory default... I think holding the UP arrow while powering on... been a while. What problem are you running into?

ICC Output profiles. As units are discontinued, the manufacturer has no access to them to create new profiles for newer media sets. One more reason to own your own profiling equipment. As long as your printer is firing, you will have, or can make, your own profiles for the very media you...

What kind of fills are you looking for Brandon?

Steph, Thank you for the video link... it clears up a lot of questions and gives everyone a chance to make a more educated decision.

Password PM'd

Do not think it can be fuses... If the fuses were bad, the entire head would not fire. Based on your information, I would change the captops, wipers and dampers. Total parts cost estimated at $200 + or - If you have not worked on the unit before, a tech would be recommended. If you are...

+1 Rodan68 Profiles made with 8.6 or higher will not work well, if at all, with 8.1. Unfortunately, I dont have profiles for the HP9000 and 790 inkset to be of any help to you. Eye1 Spectrophotometer (used) will run you about $700 or so. A new unit will run you a grand or more. Money well...

Caldera

Google "electric metal shears" Kett and Dewalt make good ones.

What version of Flexi and what printer/inkset?

Good to hear all is good.

Alarming? possible. Spitting could be caused by a slightly clogged nozzle firing at an angle... That is not a big deal. This statement, "the black cap would not spring into position correctly. This fixed itself with a dozen or so cycles as it "broke in."", does concern me... If the cap...

I would suspect Damper in this case... Sounds almost like the reservoir in the head is not being replenished by the damper. How old are the dampers? Running a clean and then a test print - ok Sit for 3 minutes, test print, no K - air getting to the head or bad damper possibly

When doing a clean on the unit, check to make sure you have ink exiting the pump to the drain bottle. This will assure that you are getting suction from the pump. How long were the printheads uncapped? You might also try to change the damper on the black head. Usually if a head continues...

Jonathan, I have been in contact with Graphix Direct and I will get you a password today. You can download the software from the following URL http://www.flexisign10.com Once I have the password from SAI / Graphix Direct, I will get you a disk on its way.