Search results

Yeah just seam it along the white part under the truck. If you stick it on one piece, you end up needing to slice in from the edge a couple inches to relieve the hump.

The spider stakes look a lot nicer. 18x24 will work with the spider stakes but if it's windy they do lean. They have shorter metal rods. Short signs like 14"H or less work great with spider stakes. Maybe get a couple and let them decide which ones they want.

Try doing 2-3 damper fills in a row. Make sure you have enough ink

Looks like polyester.

Wrap the banner around the side of the posts and screw it down with fender washers

Did the gym used to be a car dealership?

Put the wave on first. Trim the backing paper on the swish at the part that overlays the wave. Put half the swish on, let the other half lay on top of the wave. Hand cut the wave with an xacto. Then stick the other half of the swish on.

It could be custom modified from HardWork Display, Kanal, or some similar fonts.

Did you change the cap tops when you changed the heads? Did you try shaking the ink pouch? Do you see any air in the ink lines? What if you print uni-directional, is it any better?

I love seeing pharma and credit card ads on every possible surface imaginable.

Adelon-Serial-ExtraBold

Maybe air got into the ink lines. It's possible to take the back cover off and see if there's air in the lines.

Did it happen right after you replaced the inks? Do you have fluid in the cleaning pouch?

Are you using 3rd party ink? Did you check if any ink is empty?

Hard to say, could be a networking issue. Maybe you can remove AVG. Not sure if that would screw with it.

You might want to clean it with mineral spirits and windex before putting the new vinyl on.

If you add a small circle or something after the last letter, will it cut the letter then?

Try 40C heater, and 45C dryer.

heater turned on?

Amazon