xc 540

We sheet cut button works and it moves the knife but does ingage the blade can anyone help me ?

Hi guys stressing out today our PC which held our RIPS etc gave in so instead of replacing the RAM it was cheaper to buy another. I managed to get versaworks from the hard drive and installed it. We currently have 3 ROLAND printers. I have managed to successfully connect two of our RE-640's...

Hi been having an issue with our Roland xc540 get scan motor error code 0090 0080 however ive noticed its due to the ribbons getting caught.. they seem very loose / slack prints will run but then they get caught and it will show up with the error.. I am sure they are not supposed to look like...

Good afternoon, I seem to be having a problem with my Roland Soljet Pro III XC 540. I'm trying to print a 25.2' long banner and while VersaWorks (version 5.5.1) shows the artwork and all my settings, what essentially happened is that the printer rolled out all 25.2' but didn't print anything on...

Hey all! We are currently working with our go-to tech guy, but this issue is a pretty big mystery with a lot of back and forth, so I'm just throwing it on here in case any of you have experienced this before. Our Roland 54 no longer cuts consistently from day to day and even job to job. Here's...

I'm having issues with the cutter portion of my Roland XC 540. The cut carriage follows the path of the contour cut line, but the blade won't drop to contour cut. Is it simply a setting? How do I test the magnet coil of the cutter? What am I missing? Suggestions?

I am running an XC 540. My "sheet cut" feature has not been working for about a year now, but now that I am a member here, I thought I would throw the problem out there and see if anyone can help. When I try to perform a "sheet cut" the carriage runs out all the way to the left and then runs...

Hey guys. I replaced my black print head monday and now I am having alignment problems. I have a service manual and I did the head replacement completely by the book. I have since done all the test and alignments I can find and they all show that everything is perfect. But then when I print...

I've had my XC-540 for 3 years now (3 years, 4 months, and 6 days to be exact) and I've had ZERO problems thus far. However today I was printing some grey signs and noticed some terrible banding. I did a test print and noticed I had "more than" a few nozzles misfiring on the black head (a few...

I'm about to buy a Roland VP-540 by the end of the month, but when I went to a print shop that uses the VP-540, I was to say the least, disappointed. The brochure claims the maximum print speed to be 166sq.ft./hr, but the actual print speed was around 60 sq.ft/hr (a 2x3ft banner took 6.5...