Search results

I have recently changed from oki to Xerox card printer and run in to a laminating problem the same laminate will not adhere to the Xerox toner as it did to the oki toner. anybody found simular and a cure

I have seen a Roland video of creating a white print channel to be placed under a bit map containing the tone levels. as it would not work in corel never tried it

Never looked to hard as no need too notice there are 3 y belts and quite a lot of tension presume you have a manual message me if not

Hi by the sounds of it i would investigate the belt further slightest slack and the head will chatter mine will sit quietly 99% of the time. my head home position is bottom left thought that was it. personally i would not be cutting difficult stuff with the bed tilted just adds extra strain to...

Colourip is the corect rip.wasatch might still do a single printer upgrade for not a lot of money as opposed to the full version and costI still use colourrip 2.2 on my sc540 and versaworks on my vs540 compared colourrip any day for the older machine. Only downside is incompatible with some...

As said captop pipes or pump its not clearing the waste away

A couple of years ago had similar on my sc540 that I have owned from new. found that the scan cable was sticking to the multi wound drive hub light cleaning and a little light oil cured

if your print and rip queues are more than about a page full this can cause memory issues the eps files you sent are stored in a different directory you sholud know where that is. your problem is with the computer not the printer reinstall could be a option 2.2 was the last release, and still...

Still print in density control it gives a nice red

[QUOT=dethsky;1216037]http://www.mxandatvtemplates.com/ here is the website he sent me in the email. I was hoping to get these for free.... Make your own and guaranteed to fit your plastics and it's free

Think you should have environment match in the menu do that first before any adjustments its the time of year the weather temps are changing a lot.

Normal reason for that is the step value being set wrong in the driver. But no nothing of signlab controls

Coincidence my pro2 just had a heater failure my fault was the controller not turning the heaters on if your pv is going a lot higher than the sv I would suspect the controller. The controller is a standard electronic pid controller but are available from very cheap to top dollar and are...

Replaced ribbon cable 3 years ago for that reason just had to replace the pinch roller sensor so they do play up. You can go in to service mode and check each sensor action. The sensor that sets the right side is optical and mounted behind the right hand cover

I have the same machine to check first are the pumps and cap tops really doing their job correctly the deflection in black and yellow is bad saying that may be the case are the heads rubbing the spit sponge which they shouldn't causing the mixed colours generally it looks a real mess you...

if using pages or layers have you hidden any of them from view

is there any overspray in the white letters and is that green printed as well as it should, just had to change my print head due to odd things happening to the cyan it does look like a electrical issue.

As said looks like a bad vector file may have been a trace. Draw a few circles and cut to test system

Had me for a while that one. look at side of the plastic pin and find a slot to put the edge of the holder in slide back in to the bed

Be tempted to start by looking at the encoder strip as the print is being stepped over on each pass