Search results

I just upgraded from Flexi-PRO 10.0.3 to the 10.5 PDF RIP version. I had to add my printer setups back into the Production Manager once the software re-installed, and now I cannot RIP/Print anything. The job opens in the RIP/Print menu, and the second I click Send the Production Manager crashes...

did you ever figure out what was causing this? I'm experiencing something like this to a degree, but have seen similar issues from my Mutoh's in the past. I'm currently working with Signwarehouse to troubleshoot my problem, as the tech says he's never seen it before either. I wasn't sure if...

We used to run three Mutoh Falcon Outdoor 46" printers here and I had those marks show up from all three of them at different times for different reasons. One was fixed by grounding a screw to an outlet, and the others were either Head cable replacements or a dirty/damaged encoder strip...

I am having an issue with my plotter. Yesterday, a fellow employee used the Cut/Plot option in flexi to plot out a menu board. Normally, all of our cutting is done through the Rip/Print option and selecting Contour job only. Later in the day, when we returned to cut another job, the plotter...

I am currently running a Mutoh Prismjet Extra 48" printer bought from signwarehouse. I attended a training session last week and the printers were left dormant all day friday and the following weekend. I normally have to take some time to recover all nozzles and get a good nozzle check after the...

I have a falcon outdoor 48" and factory tubing seems to be very expensive for just tubing. Does anybody know what type of tubing the ink lines are and also what type of tubing the drain lines are. The tubing i just bought the Eco solvent ink ate right through them in about 2 days.

i just did it in the dark and stiil did not work, now do you know how to get to maintenance mode and check it through the board as you said?? I do not have the maintenance manual for the printer.

sorry it the the falcon outdoor 48"

it is one thing arfter another with my printer. I have just replace the print heads and when i tried to do the nozzle check and tilt alignments the print will not recognize the media. I have it lined up right being half way over the 2 holes on the right, and i also switched out the media sensor...

i keep thinking i am going to buy the service manual, but i will look under the platten ty for your help.

heater fuses. by any chance do you know where they would be???

I am having some trouble with my printer. The control panle on the falcon outdoor 48" says the heaters are on but they do now warm up once printing starts. Does anybody7 have any ideas on are to look. I have checked both ends of the cable from the control panel and both ends are connected tight...

power down problem there is inkn in the damper but when i do the nozzle check it powers off 2 inches into the nozzle check patter. then i have to unplug the maching and plug it back in to get it to power back on and then it does the same thing.

Hello been having problem with my faclon outdoor printer. No ink was coming out on the nozzle check so i was advised to replace the print head fuses. and i also replaced the print head cables.. I uncharged the machine before i worked on it. Now when i go to print the nozzle check it stops 2"...

replacing fuses I could not find anything on the forums is there any other place to look???

fuses doesn't say much qabout the fuse process agree, this is a good consideration that it is a blown fuse but how can i test the fuse, where can i buy them and how do i replace them.

Replacing the fuses I just bought and ebay special and i am having the same issue of no ink out of the print heads. how do you test the fuses to see if they are blown and if they are can the be bought easy enough and installed or does one of the big dollar technicians have to do it.