Search results

Without reading replies...double sided laminate..same as you do when doing glass top or perspex top tables or signs.

Only ever got that type of error if I didn't transfer job from usb stick to hard drive

Check the pins on the old cable and see if the outside one is damaged..you may have fried that head

Photo eye sensor for media

Some excellent replied and finally, pick a font that is easily available Fancy > Western fonts | dafont.com

Did you give the machine a static shock or did the machine give you one,,,Seriously need to get it checked out or it could potentially kill someone.

Have you sorted any problems with the VS that it may have had??.. has it paid for itself and you?? Put a new scan motor in it and keep it going.. why buy a new printer when the heads are the same?? just saying

With the info you have provided, I'm guessing you have had a mainboard failure. If you haven't had the right hand cover off and unplugged the display and not reconnected it properly, that is the only thing left. Do all the leds flash or are they showing as though the are all jammed on?? From...

Last resort..remove the dampers from your cyan heads and gently syringe some cleaner into the heads and leave it over night and let it soak. After the soak, try syringing at a little higher pressure and push a full syringe through each channel until all nozzles are clean. Refit the dampers and...

Scan it, digitize it and print what you have in that image.. take you 5 minutes.. :)

You need to go back to basics and ensure the supply lines and cartridges are allowing the inks to flow freely when syringing inks through. Also recheck your dampers to ensure they have not blocked up. You then need to manually flush the heads to ensure all nozzles are clear. Syringe inks...

https://signs101.com/attachments/1123-jpg.132254/ Check these fuses and also check your cables are securely plugged in.

Are you allowing time for the heaters to reach temperature?? are the heaters actually working??

Time to clean your fans me thinks :)

Hows the new mutoh going??

Crank you platten heat up to 50 degrees and test it.

I do it using hospital grade surgical tube an suck directly on the affected area.. The silicon tube is softer than other commercial grades and doesn't damage the heads in any way. Its softer than the wiper that wipes that head thousands of times in its lifetime Count the missing line vertically...

Three nozzles are blocked on the front end your cyan head. Requires a manual suck with a syringe on the front only where those nozzles show in the test print

Agree with VanderJ, would be checking the servo board. Location is the board behind the heater control board to the right of the main board. https://www.sign-in-china.com/products/4345/original_roland_sp_300v_sp_540v_servo_board_7840605600.html

If you cant suck ink with a syringe directly from the dampers, your lines are blocked somewhere. Would also be checking heads if it has been sitting with nothing in them. You will need to remove all covers to get at the fittings at the cartidges