Search results

Flexi? Onyx? SignLab? - The probably all have the drivers for it.

Look Here

A proper PM visit on those included new cap tops and new prime assemblies. Have you replaced those? Have you tried a new ink cartridge? I'm afraid if you left it unplugged you may have a very big boat anchor. Sometimes it makes more sense to involve a dealer who can help you avoid such gotchas...

You've prooved my point about what we would know about laws over there. I couldn't even get the form of government correct:oops: I didn't realize it was the same person either till I did the search to prove the point that this question has been asked and answered.

Try cleaning the grit encoder disk and sensor on the left end of the machine. This is what tells the printer how far the grit wheels have turned. I would suspect an error code would pop up, but this might just be the cause. It's a clear plastic disk with tiny marks that the sensor counts as...

Actually the whole "using copyrighted or trademarked artwork without permission from the owner" question has been hashed out before. This isn't much different than your previous post: There are about 10 pages in my search for the word trademark. And no, it's not a totally different question...

Is your black print head still misdirecting jets? Can you change the color to cyan and print again just to see if it is color related?

This? Again??

Have you done your feed and bi-directional calibrations? What print mode is that?

No. As VanderJ said, replace the clamps (contact a Roland distributor). I wouldn't use them till they are working properly. Also, if the corners (edges) of your media are bent up so much that they're hitting the print heads, they may have enough force to lift the edge guards into the path of...

Something's amiss here. If ink flows through to the waste ink bottle when cleaning, it should flow through when pulling with a syringe. Are you pulling directly from the captop or trying to pull through the pump? If you move the carriage aside and put cleaning fluid on the captop, can you pull...

Are you syringing from the captop directly or doing it from below the pump? If ink comes through when doing a cleaning then it should come through with the syringe. If you move the head out of the way and put some cleaning fluid in the captop, can you pull that through? If he's been removing...

Good points above, also make sure that you don't have any power saving features turned on on the computer that might get in the way of production.

Does any ink flow through?

If you syringe from below the captop, do you get air or ink or resistance?

You should ask the company that sold you the inks or Triangle themselves. Were you using Triangle inks before or did you just start using them from some other brand or OEM?

As AlsEU said - you never know. If you did this per the supplier's instructions, I would still be asking them for a resolution. The only hack that I could think of would be to use a cleaning fluid (the OEM or the third party - not sure which would be more effective) and try to get the head to...

Good luck Matt!

I'm not familiar with that specific vinyl, but if you can't find one for it on Rolandprofilecenter.com, then I usually go with the PCV4 profile for cast films and GCVP profile for calendared films. They usually do a pretty decent job for a "generic" profile.

Nice Job!