Search results

As time goes by and you get used to it you will be using different spot ribbons in odd carts to print what you want

Don't know if its the same for the pc600 but on a 60 that sequence says it's missing a colour that it wants to use. All the carts are bar coded

thanks Kev hope the snow not to bad around you we have none whatsoever till you go to the east of us. i am sure i have noticed the colours change with those settings why i always try and stick to one. rjssigns thanks for reply, when you say its been a while since printing do you mean with the...

Any body having success with the pantone colour system. My first attempt not right Vs540 lmlc mw looks like it has accepted the eps info and the spot colour but printed results not close enough. Should the sign and display part be used or set to something else? Thanks

make sure the vinyl is 100% square and that the roll carrier is square, also found that if the pinch roller is too close to the edge it will try and bunch up as you call it.

Wrapping a whole panel like the door would be easy. When you want to finish in mid panel has to be designed in. Printing on to white and cut to a printed edge will often leave a white edge if viewed at a angle. Try ing to print the paint colour is harder than you think. To fade the design in...

Where do you think it will be cut on the wings. It could spoil the whole effect. I print white and think you will struggle against the black background. Normally expect that type of design to be part of a wrap. If to be print and cut then needs hard colour edges then could be printed to...

It wants you to set the head to low position make sure also that the media clamps are out of the way.

Oh yes forgot the premask as you call it. I use the cheapest clear or laminate as you say normal paper don't do it.

i use a adhesive cloth from bainbridge its whats used for the sail numbers. have cut it in a roll cutter but care required, cut very nicely on my flat bed.

Been trying the same on my vs could do cmyk wt then a white. But as you may have noticed it prints faster doing 3 separate prints. Found that the estimated ink level doing this is a mile out compared to the actual ripped amount. Try never to cut through print on cling a small clear area...

well done and pleased for you. always a problem explaining things at a distance when you don't know how capable somebody may be.

haven't seen one that far out before presume the red is meant to be with the black looks like the black head has moved as the red, - yellow and mag look ok from here. have you had a head strike or the head separate that's the most common result. re alignment is a careful fiddly job and the head...

i have a graphtc fc2250 180 very handy for some things, but would never have bought a new one, lucky enough to find a good cheap used one. if having to buy new may hold out for a zund.

hi and welcome from the UK i have a sc540 see if you can load some pics. all the colours are aligned to the black head which should be the first head. alignment is made through mechanical adjustments by printing several alignment patterns then adjusting the head position finished of with...

tried that on my vs540 run the risk of the print not quite lining up, fine on shorter bits

+1 on static, used any odd materials lately. enjoy from cornwall

thanks for the up date i can't work out how old mine is between 12 15 years after it was 2 year old i got so desperate with the printing i, pulled my card out of my pocket and bought a epson. since then the graphtec has only cut vinyl. 3 cutting strips, new ebay blade every 6 months and a...

yes that's how to do it as we do. can't remember but one of the "F" buttons will over ride the roller finding bit. the reason is because the little silver bar on top of the pinch roller is used to find the roller. but it sees the material instead, causing upset. latter graphtecs find the...

sorry its to complicated to explain but there are youtube demos on how its done.