Search results

There is something funky about that file. When I open it in Illustrator it has a clipping mask and acts really weird for a file that should be just a square. What design software do you use?

Yes unfortunately on the JV3 you have to have all 8 cartridges in. They added the ability to run off of only 4 cartridges on the JV33 but yours does not. I'm sure with some ingenuity someone could figure it out but it isn't a built in function.

When it says it's printing for a second and then disappears it means your port settings are not setup correctly. What machine are you trying to connect and which type of connection is it.?

I would say change the cord to rule it out. Normally when connections are in and out it's because of a bad cable or piece of hardware. If the new cord doesn't help then you might have a bad network card on the comp or printer. Also, as stated above. Makes sure the IP settings on the printer and...

Unfortunately I can only get the whole assembly and it's $356 from Mutoh America.

How does the printer print on other vinyls?

From what I see it looks like you are possibly using cheap vinyl and/or the heat settings are too low. The ink is pooling up rather than spreading and drying. Unfortunately this happens more often with the ES3 inks. My first recommendation would be to switch to the SS21 inks which dry faster and...

You can get just the flange if that's all you need for much cheaper. Mutoh Flange

Joe is right. Change the dampers first including the o-rings. If that doesn't do the trick the next part to change is the cap top. Also, when a cartridge flags as empty when it really isn't, usually the little sensor that detects if it's empty or not is broken. Get a flashlight and look into one...

The easiest way to get the template lines to be cut lines is to create a spot color called, ""CutContour" and then apply it to the line. You can do it in illustrator or Flexi and it will work. Then when you go to RIP and Print there will be a new tab you can click on for the cutting settings. In...

I started shoveling lasagna and pizza into an oven at 14. From there I have had at least 15 different jobs including selling shoes, housekeeping at a nursing home and hotel, cashier at a stop and shop, graphic designer at a small sign shop, dish washer, desserts, sides and salad guy at a fine...

Depending on how old the machine is and what firmware it is running, it's going to be in the setup menu and called either "flushing" or "spitting." Set the setting to "origin" instead of "on media."

PS empty the waste tank before you leave to avoid a mess!

Run the custody wash and when it asks you to clean the wiper, clean the cap top as well. Follow the rest of the instructions and set the timer to 10 minutes only. Basically what a custody wash is doing is running a nozzle wash to make sure your nozzles start out perfectly clear and to remove any...

The Daige Solo laminators are good entry level laminators. You will be looking at around $1400 for the 38" version but you could probably talk a dealer down a little more. It is a bare bones settup that doesn't come with a stand so you have to buy one or make your own. I know some guys who just...

2.0 is the lowest official Firmware so to get anything lower you have to find someone who just happens to have it in their misc folder. You should be fine using the 1.8 as the parameter file only changes with full version #'s.

You have bad ink then.

Most Arlon Vinyl is manufactured here in the USA unless it changed after Flexcon bought them out.

When you connect the printer to the computer it should install the driver in windows. Once that finishes then when you go to add a printer in Versaworks you should be able to choose a USB port and then hit verify. If everything is working right it will automatically see the SP300 and then you...

SP300Vs don't have Ethernet connections and therefore no IP address exists. USB only.